Something for installing car audio system

Something for installing car audio system
To decide after reading a good configuration and brand to install when. Stroke is a description of how a good audio system in a car to build. Based on my experience, my mistakes and strengths. All I know is pure hi-fi. If you build a car straight from the pen this article as a guide.

The end result of the installation depends on the installation. A good team and a bad setup for a bad result. A chain is as strong as its weakest link.
The speakers are on the box and the amplifier off, the amplifier depends on the current and the current is the son and the alternator. An error in each step and the end result will be disappointing.


Step 1 - Where?
President shall designate the location sound. The problem with the car is the fact that the auditor is not between two speakers, but in one corner, a speaker than the other. The distance between the left and the left ear is not the same as the distance between the right speaker and right ear. Try to make the difference between the distance to the left and right as possible. Placing the speakers near the earth makes the work, but runs the risk of noise from below. Placing an extra speaker in the dashboard is not the RIP and that in half.

To find the perfect place to temporarily install car speakers in boxes. This test is only found in a place that is not very poor due to the minimal coverage of the boxes is a problem. Play at low volume, the speaker can also be controlled with an audio system, and move the speakers to be found around the car to the location ideal. Listen, do not see. Some places can probably get a good test for his audio.

Place the subwoofer can not be found with this method. Location amplifiers and other devices are unique cosmetics. Also remember that some devices interfere with each other.
Step 2 - Cable and DynamatNow know where to add the speakers and other devices can. The time of the first layer: Dynamat. Dynamat (and similar materials) are used to stop the car vibrates and to prevent the metal plates to bring the sound of a fork. Dynamat sound insulation is not! I used Dynamat on my door to make sure that no metal part of the speaker box (which refers to the bass sound) are. Dynamat some use in the car, I think it is overcooked.

Next, the metal wiring. The cables are the first link in the audio. Screw this part and not the whole system work. Some people are very amp, but not always as expected. To visit a store to a powerful amplifier. Here, too, do not supply the amplifier. In fact, you just need a good cable. It's like a sports car with a fuel line super thin. An engine needs enough fuel to complete. An amplifier has enough power needs.
Step 3 - the main unit and amplifier (s) There is no son and no power. It's time to connect the main unit and amplifier. Start by installing the main unit and optional CD changer and power amp (s). Some choose to feed the main unit with a cable factory, others a separate circuit for the main unit. It depends on the quality of the audio-processing plant. The amplifiers each have its own fuse. Use a good cable, not to jump on the quality of power distribution blocks and terminal blocks.
Filters (as described in the configuration page), must now be installed.

Connect a speaker to an amplifier to see if it works, but the game at a very low volume that the speakers do not have a place yet.
Please go to http://www.12vcity.com/content/node/160 to know more.